The sensor green wire will connect to the ground wire in the wallbox.
Cooper motion sensor light switch instructions.
Make sure the sensor is not picking up moving objects such as trees traffic etc.
Unit is in override mode if there is no motion.
Switch or in the unlikely event of a failure of the motion sensor.
In either mode the.
Reposition the sensor.
There is motion in the detection zone.
When unit stabilizes about 1 minute the sensor is ready to detect motion.
Press and hold the on off button for 10 seconds until the indicator led blinks for the second time the led will also blink at the 5 second point.
Set the switch to the auto mode.
Motion is detected the lights will turn on.
Apply power and wait one minute.
Two locations one location is the sensor and the other location is a standard 3 way switch two locations replace both 3 way switches with sensors in automatic on mode the lights turn on automatically when a person enters the room.
Select a location that is 6 to 8 feet above ground level.
The sensor blue wire is not used and should be capped off with a wire nut.
Install the sensor loosely using the mounting screws provided.
Match up screw holes on the cover plate with the junction.
The lights will turn off 5 seconds after motion is no longer detected.
Turn the light switch to the off position for 40 seconds and then turn back to the on position.
The sensor black wire will connect to the hot wire in the wallbox.
Turn the light control knob all the way clockwise to the moon symbol dusk position fig.
Turn the power back on at the circuit breaker.
Install your fixture near a doorway or pathway to.
Automatically release the button while the led is blinking.
The sensor red wire will connect to the wire which goes to the light fixture.
Rotating the light adjustment knob will control at what level of brightness the motion sensor will turn the light on when it is in automatic mode not test mode.
Turn off power at the main fuse or breaker box.