To enter the bios you need to reboot your computer and press a certain key.
Control fan speed connected to power supply.
Pulse width modulating pwm the fan directly involves turning the fan s power supply on and off at a fixed frequency.
A fan connected this way can be controlled by g code and you can tell your slicer when and how fast to run it.
Would a 3 pin fan work on a 2 pin slot.
Bios settings before moving on to any fan speed control software try digging into the system s bios.
The cool air drawn from the outside of the system will help cool down the power supply which will in turn ensure that the power supply operates at its utmost efficiency.
If they re connected to the power supply usually through a molex connector there s no way to control them through software you d have to hook them up to a hardware fan controller.
If the fan bearings were seizing the fan would not start.
The larger the duty cycle the faster the fan spins.
The fans in your computer can get power in one of two ways.
Duty cycle adjustments are made to control the speed of the fan.
Most modern computers already have built in controls there.
Edit nr 2.
The 120mm enermax branded fan eb122512h is controlled to rotate between 450 rpm and 2 000 rpm depending on the ambient temperatures.
If you have room tape another 120mm fan to the bottom of the psu to drive.
As far as the ramps is concerned there is a spot for a 2 pin header near d2 that breaks out permanently on 12v.
Choosing the appropriate frequency for this method can be somewhat tricky.
From the motherboard or directly from your computer s power supply.