The sink stopper replacement starts by inserting the stopper into the drain.
Connecting sink drain stopper.
Water may leak or refuse to drain around a sink pop up for a number of reasons.
Instructions remove the old drain assembly.
Prepare the new pop up drain stopper.
The pivot rod extends horizontally out the back of the drainpipe under the sink and connects via a small spring clip to the vertical lift rod that lies on top of the faucet assembly this is the little mechanism you push or pull to engage or disengage the drain stopper often these thin metal rods can loosen with repeated use.
Loosen and remove the p trap from the branch drain and sink drain tailpiece using.
I currently have no stopper in the sink because the stopper wouldn t stay open.
If it is stuck you may need to turn it a quarter turn before it will.
See below for a shopping list and tools su.
My sink has some small cracks in it starting at the drain and going outward into the bowl which have been sealed.
Look down into the drain and pull up the pivot stopper bar which the pivoting rod is attached to with the control.
Apply pipe joint compound.
The problem is with my pop up mechanism.
This old house plumbing and heating expert richard trethewey shows how to replace a faulty pop up sink stopper.
Install the stopper place the stopper into the drain from the top and ensure the hole is facing the back of the sink.
Slide the clevis the flat slotted bar over the pivot rod and then push that rod into the drain.
How to fix a sink pop up drain stopper.
Attaching the new sink stopper drain 1.
Take a small handful of plumber s putty from its.
I m afraid that removing the finished flange will make it crack more.
Lift the pivot stopper out of the sink drain.
Returning to the bottom take the nut with the ball on the inside and thread it into the drain pipe.
Disassemble the pieces of the new pop up assembly and unscrew and remove the.
If your sink pop up won t pop up or seat properly fixing it is quite easy usually just a matter of adjusting a few parts.
How to connect the pivot stopper in a sink 1.
Press firmly enough that plumber s putty squeezes out.
Apply a thin layer of.
Replace the nut you removed from the horizontal rod but tighten it only lightly just enough to hold the rod in place.
Push the new sink drain into the opening and onto the putty.