Tighten the compressing fitting using two adjustable wrenches.
Connecting kitchen sink drain pipe.
Connecting the drainpipes 1.
The drain tailpiece is a straight pipe that connects to the sink strainer and runs down to a tee fitting below the sink basin without the disposer.
Cut and dry fit the horizontal drainpipe and the fittings for connecting the tub and the sink drains.
To avoid this cancel and sign in to youtube on your computer.
Now attach the one end of the pipe to the second outlet on the airgap stem the same way you attached the dishwasher pipe to the first outlet.
Turn off the water to the sink cabinet and remove the cabinet doors for easier access.
Use a measure tape to check the distance from the larger outlet on your airgap to the drain line for your kitchen sink.
A 3 inch horizontal pipe is shown but your inspector may permit a 2 inch pipe insert a street elbow into the y and hold the other pieces in place to mark for cutting.
Install the tailpiece and continuous waste pipe.
A rubber compression gasket is a small flexible gasket.
Reattach the trap to the tailpiece and into the drain line.
Place a rubber compression gasket inside of the drain pipe.
A single trap can service more than one sink but adjacent drains cannot be farther apart than 30 inches.
When one or more of the nuts loosen or crack the seal is ineffective and the pipes leak as.
The tailpiece and waste pipe must be cut to length for installation.
The horizontal pipes connect to the trap with a double wye tee which has two y shaped inlets and one outlet.
Horizontal drain pipes connecting the sink drains to the trap must have a minimum slope of 1 4 inch per foot toward the trap.
Videos you watch may be added to the tv s watch history and influence tv recommendations.
Attach a brass tailpiece to the bottom of the basket strainer.
Sink drain connections consist of large ring nuts that tighten against nylon washers and provide a seal.
Take a brass tailpiece and line up the threads with.
Attach a shut off valve to a length of copper tubing.
Slip the trap onto the tailpiece and then position the trap s horizontal piece next to the drain line coming out of the.
Hold the top of the.
Start by attaching the tailpiece to the sink drain and tightening the slip nut and washer by hand.